Eicon Networks S52 Uživatelská příručka stáhnout pdf (Strana 88)

X.3 PAD Parameters

page 86

12:n Flow control of the PAD by the workstation

This parameter allows for flow control of received data using X-ON and X-OFF characters. The

X-ON character is DC1 (Ctrl-Q) and the X-OFF character is DC3 (Ctrl-S).

13:n Line Feed insertion after Carriage Return

This parameter instructs the workstation to routinely insert a Line Feed (LF) into the data

stream after each appearance of a Carriage Return (CR) character.

Coding of parameter 13 can be a single value or the sum of any combination of values listed

above.

14:n Linefeed padding

This parameter provides for the automatic insertion of padding characters, by the PAD, to

allow for a time duration delay after each linefeed character. This allows a printing mechanism

to correctly perform a line feed.

15:n Editing

This parameter allows you to perform local editing after a connection is made with the host.

If you enable local editing (set parameter 15 to 1), you can correct any data buffered locally,

rather than sending it across the network to the host for later correction. When local editing

is allowed, the workstation monitors for characters which have been assigned per 16

(Character delete), 17 (Line delete), and 18 (Line redisplay).

Local editing cannot be enabled unless the idle timer (parameter 4) is set to 0.

Value Description

0 No use of X-ON and X-OFF

1 Use of X-ON and X-OFF

Value Description

0 No LF insertion

1 Insert a LF after each CR in the received data stream

2 Insert a LF after each CR in the transmitted data stream

4 Insert a LF after each CR in the echo to the screen

Value Description

0-15 Any number from 0 to 15, which indicates the number of padding characters

to be inserted after a linefeed

0 No padding characters inserted

Value Description

0 No editing in the data transfer state

1 Editing in the data transfer state

1 2 ... 83 84 85 86 87 88 89 90 91

Žádné komentáře

Eicon Networks S52 Uživatelská příručka Strana 88