Eicon Networks S52 Uživatelská příručka stáhnout pdf (Strana 49)

Eicon Connections for Linux User’s Guide

page 47

16. Run ecstatus ppp to confirm that the link between Sys-1 and Sys-2 is operational. The

Protocol State item appearing in the left column of the ecstatus display should be listed

as “Opening” on both systems.

Check that the circuit is correctly defined on both systems and that the two circuits are

bound by using the mprstat -c command. The systems display the following:

If there is an “E” in the Flags column, the binding of the circuit may be incorrect. Determine

what the error is and correct it. You can use the mprstart command to restart the circuit

or the mprstat -cv command to display detailed status information for the circuits if

necessary.

For more information on the ecstatus command, see ecstatus.html in the

/opt/dialogic/c4l/docs directory.

17. If the circuit states are set properly, go to the Testing Sys-1/Sys-2 Communications on

page 51.

Setting up a PPP Connection using PAP and CHAP

You can set up a Point-to-Point connection using PAP (Password Authentication Protocol) and

CHAP (Challenge Handshake Authentication Protocol) on Sys-1 and Sys-2 by following this

procedure.

1. Select the Eiconcard Services Protocol Configuration option in eiconcfg on each system

to modify its Eiconcard configuration.

2. At the Hardware Configuration screen, set auto activate ports to No for the PPP ports.

3. Move to the Protocol Configuration screen. Select Routing Services.

4. Configure the Line protocol module as PPP on both systems.

The default values on the Point-to-Point Configuration screen do not need to be modified

for a back-to-back connection.

5. Press F4 twice to access the Password Authentication Configuration screen.

6. On Sys-1, set the password authentication parameters as follows:

Local PAP User Name System1

Local PAP Password Pass1

Remote PAP User Name System2

Remote PAP Password Pass2

Local CHAP User Name Sys1

Local CHAP Secret Password

Remote CHAP User Name Sys2

[Sys-1]# mprstat -c

cctname Subnet Flags Port Comp Parameters First Hop I/F

test_pp

PPP OPB 1 Off 192.1.100.

eic0

[Sys-2]# mprstat -c

cctname Subnet Flags Port Comp Parameters First Hop I/F

test_pp

PPP OPB 1 Off 192.1.100.

eic0

1 2 ... 44 45 46 47 48 49 50 51 52 53 54 ... 90 91

Komentáře k této Příručce

Žádné komentáře

Eicon Networks S52 Uživatelská příručka Strana 49

Komentáře k této Příručce

Související produkty a manuály pro Sítě Eicon Networks S52