Eicon Networks DIVA T/A ISDN Modem Uživatelská příručka Strana 156
- Strana / 191
- Tabulka s obsahem
- KNIHY
Hodnocené. / 5. Na základě hodnocení zákazníků
Appendix C: Command Line Reference Call screening
156
number2: USERSPEC only. This is the second number that the server dials when calling back. For example, if
you have two ISDN numbers, and you want to establish an MLPPP connection, the server must call in twice,
once to establish each channel.
SET CALLBACK TIMEOUT seconds
Valid context: Profile/PPP
Sets the amount of time the DIVA LAN ISDN Modem waits for the server to call back. During this time, the
DIVA LAN ISDN Modem will refuse incoming calls that are not from the callback server on the phone number
that was configured for callback.
seconds: Length of delay in seconds. Range: 20 to 240. Default: 30.
SET CALLBACK DELAY seconds
Valid context: Profile/PPP
Callback control protocol only. Sets the amount of time the server waits before calling back. The DIVA LAN
ISDN Modem proposes the delay during callback negotiation. The server can either accept or reject it.
seconds: Length of delay in seconds. Range: 1 to 30. Default: 5.
SHOW CALLBACK CONFIGURATION
Valid context: Profile/PPP
Displays the current setting of all callback parameters for the current profile.
Call screening
ADD ISDN SCREENING channel number
Valid context: General
Adds a number to the call screening table. When call screening is enabled, an incoming data call is only
accepted if its number appears in the call screening table.
Use this command to add a number to the call screening table.
channel: ISDN number to screen calls on. Range 1 to 2.
number: ISDN telephone number to screen for. Enter up to 20 digits. Call screening does not support
subaddresses.
DELETE ISDN SCREENING channel index
Valid context: General
Removes an ISDN number from the call screening table.
channel: ISDN channel to screen the number on. Range 1 to 2.
index: Index number of the table entry to delete. Range: 1 to 10.
ENABLE ISDN SCREENING
Valid context: General
Enables or disables ISDN call screening. When enabled, an incoming data call is only accepted if its number
appears in the call screening table.
DISABLE ISDN SCREENING
Valid context: General
- DIVA LAN ISDN Modem 1
- User’s Guide 1
- Table of Contents 3
- Chapter Three: 4
- Chapter Four: 4
- Chapter Five: 4
- Chapter Six: 5
- Chapter Seven: 5
- Chapter Eight: 6
- Chapter Nine: 6
- Chapter Ten: 6
- Appendix A: 7
- Appendix B: 7
- Appendix C: 7
- Appendix D: 8
- Introduction 9
- Internet 10
- Connecting more computers 12
- Total network security 12
- Summary of features 13
- Contacting customer services 14
- Getting Started 15
- 1. Installation overview 16
- 2. Prepare for installation 17
- Important ISDN concepts 19
- ISDN channel usage 19
- Multilink PPP 20
- Multilink PPP + BACP 20
- Multilink PPP + AO/DI 20
- Gather ISDN information 22
- Gather X.25 information 23
- Gather V.120 information 23
- Power Supply 24
- FaxPhone 24
- ISDN Wall Outlet 24
- To install Modem Monitor 26
- What’s next? 34
- Starting Modem Monitor 36
- Properties dialog box 37
- Utilities dialog box 38
- Options dialog box 38
- Status Viewer 39
- Profile table 40
- Utilities 40
- Chapter Four 41
- Saving configuration settings 43
- Getting help 43
- General settings 43
- Connection profile settings 43
- Editing the ISP profile 44
- Editing LAN settings 45
- Viewing status information 46
- Obtaining statistics 47
- Eicon\DIVA LAN ISDN Modem\ELM 48
- Resetting to factory defaults 49
- Minimizing ISDN Charges 50
- The Cost Control page 51
- Data call thresholds 52
- ISDN billing intervals 52
- Configuring BACP 53
- Configuring AO/DI 54
- X.25 on the D-channel 56
- Click Save 57
- Click Reset 57
- Setting ISDN active intervals 58
- Spoofing NetBIOS services 59
- Data compression 60
- Manual dialing 61
- Restricting analog calls 62
- Data over voice 63
- Traffic filtering 64
- Security 65
- Security features 66
- System password 67
- Automatic log out 67
- Network address translation 68
- Remote management 70
- Incoming data calls 72
- Call authentication 74
- Custom security features 78
- Setting up the Phone Ports 79
- Assigning phone numbers 80
- Call bumping 84
- Supplementary services 86
- Call Hold 87
- Call Waiting 87
- Notes on call bumping 89
- Call Forwarding 90
- Three-party Conference Call 91
- Terminal Portability 92
- Chapter Eight 93
- Overview 94
- 1. Gather information 95
- Minimizing your ISDN charges 100
- Configuring security features 101
- Advanced Installations 102
- Connection retries 103
- Using Modem Monitor 104
- Manual installation 105
- 106 106
- To create a VPN 108
- Connecting to the VPN 109
- Defining routes 110
- IP routes 111
- 117 117
- 118 118
- IP filters 119
- Default filters 120
- To define a filter 120
- Action Direction 121
- Source /Destination 121
- Location 121
- ProtocolAddress 121
- 122 122
- IP filtering examples 123
- 124 124
- Blocking web surfing 125
- 126 126
- Making a V.120 connection 127
- 128 128
- SecurID support 129
- 130 130
- Other Configuration Tools 131
- Configuration options 132
- Web interface 133
- TFTP interface 133
- 134 134
- DTMF interface 135
- Command line interface (CLI) 136
- 137 137
- About configuration context 138
- Connection profiles 138
- Default profiles 138
- Command line reference 138
- Loading firmware with the CLI 138
- 139 139
- TCP/IP Configuration 140
- Installing TCP/IP 141
- Configuring TCP/IP 141
- 142 142
- 143 143
- 144 144
- Configuring TCP/IP on an iMac 145
- Technical Information 146
- 147 147
- E1, E2, E3, E4 148
- 149 149
- 150 150
- Termination 151
- Command Line Reference 152
- Notational Conventions 153
- Commands 154
- Callback 155
- Call screening 156
- Call thresholds 157
- 158 158
- 159 159
- Ethernet 160
- 161 161
- 162 162
- 164 164
- 165 165
- 166 166
- IP routing 167
- IP various 167
- 168 168
- 169 169
- 170 170
- 171 171
- ISDN Access Time 172
- Logging and Mail Trace 173
- 174 174
- SHOW MLPPP CONFIGURATION 175
- 176 176
- 177 177
- 178 178
- 179 179
- 180 180
- Profiles 181
- 182 182
- 183 183
- 184 184
- Time Protocol 185
- 186 186
- V.120 Scripting 187
- 188 188
- 189 189
- Regulatory Information 190
- Safety Status: TNV-1 191
- Power Consumption 191
Související produkty a manuály pro Sítě Eicon Networks DIVA T/A ISDN Modem
Sítě Eicon Networks Eicon 1550 Specifikace
(8 stránky)
(8 stránky)
Sítě Eicon Networks 800-241 Uživatelská příručka
(52 stránky)
(52 stránky)
Sítě Eicon Networks 1530 Uživatelská příručka
(162 stránky)
(162 stránky)
Kwikset Cordless combi drills user manuals
The list of Kwikset Cordless combi drills products contains 1 user manuals for 1 models. All pdf user’s guides are available for download or viewing online.
Komentáře k této Příručce