Eicon Networks C20 Manuál s instrukcemi stáhnout pdf (Strana 207)

100

101

INTUITY Messaging Solutions Release 4

MAP/5P Maintenance

585-310-186

Issue 3

October 1997

Replacing the Hard Disk Drive

Page 6-9Recovering from a Hard Disk Drive 0 Failure

Figure 6-5. Information Window

d. Press .

The system displays the Alarm Management window (Figure 6-4

Reconfiguring Both Hard Disk Drives

Because the Lucent INTUITY system must boot off of a hard disk drive with the

jumpers configured to be SCSI ID 0, you must reconfigure both hard disk drives.

To reconfigure both hard disk drives, do the following:

1. Remove Hard Disk Drive 0. See ‘‘Hard Disk Drive 0 Removal’’

below for the

procedure.

CAUTION:

Return to Step 2 of this procedure before you install the replacement

hard disk drive.

2. Remove Hard Disk Drive 1. See ‘‘Hard Disk Drive 1 Removal’’ below for the

procedure.

CAUTION:

Return to Step 3 of this procedure before you reinstall Hard Disk

Drive 1.

3. Change the jumpers for Hard Disk Drive 1 to the correct positions for Hard

Disk Drive 0. See ‘‘Setting the Hard Disk Drive 0 Jumper Settings’’

below

for the correct settings.

4. Replace the changed Hard Disk Drive 1 in the position reserved for Hard

Disk Drive 0. See ‘‘Inserting Hard Disk Drive 0’’

below for the procedure.

NOTE:

This hard disk drive is now Hard Disk Drive 0.

5. Set the jumpers on the new hard disk drive to the correct positions for

Hard Disk Drive 1. See ‘‘Setting the Hard Disk Drive 1 Jumper Settings’’

below for the correct settings.

ENTER

1 2 ... 202 203 204 205 206 207 208 209 210 211 212 ... 409 410

Komentáře k této Příručce

Žádné komentáře

Eicon Networks C20 Manuál s instrukcemi Strana 207

Komentáře k této Příručce

Související produkty a manuály pro Sítě Eicon Networks C20