Eicon Networks S93 Instalační příručka stáhnout pdf (Strana 19)

Basic drivers 19

4. If you have selected the ‘RBS T1’ switch type:

• Select the trunk type that corresponds to the trunk type of your switch:

• Wink Start

• Loop Start

• Ground Start

Default setting is ‘Wink Start’.

All trunk types are defined in the TIA/EIA-464B specification; the ‘Wink Start’ trunk

type is also defined in AT&T TR4158.

• Select the dial type that corresponds to the dial type of your switch.

• Pulse

• DTMF (Dual-Tone Multifrequency Signaling)

• MF (Multifrequency Signaling)

Default setting is ‘DTMF’. Most analog telephones use dual-tone multifrequency

signaling.

5. If you have selected the ‘Q-Sig’ switch type:

• Select your ‘PBX Type’ from the list. If your PBX is not listed, select ‘Generic PBX’.

• Specify the Q-Sig standard. Normally, the correct Q-Sig standard is automatically

set for the selected PBX type. Change this value only if your PBX requires a different

value.

Specifics of all Diva Server 4BRI and Voice 4BRI adapters

With a Diva Server 4BRI or Voice 4BRI adapter, each of the four controllers (controller [1]

to controller [4]) can be enabled or disabled individually. To do so, check or clear the check

boxes for each of them.

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 129 130

Žádné komentáře

Eicon Networks S93 Instalační příručka Strana 19