Eicon Networks C21 Instalační příručka stáhnout pdf (Strana 82)

ECDIALER and ISDN 82

Using ECDIALER with 5ESS (AT&T)

This section describes how make an ISDN connection to the 5ESS switch type.

ISDN AT&T 5ESS Parameters

The following table lists all the ISDN AT&T 5ESS specific parameters for

ECDIALER:

ECDIALER STORE

ECDIALER STORE permanently replaces whatever value was previously

configured or stored.

Parameter Explanation

/Main n

Stores the main telephone number. This is the first number dialed

when you issue the ECDIALER DIAL command without a

number parameter. This option is not required for packet calls

when connecting to ISDN through a 5ESS type switch.

/NUmber n

Dials the number specified, regardless of what is stored as the

main telephone number.

/SAddr subaddr

Provides the subaddress to further identify the remote terminal

on the ISDN Basic Rate Interface. If two terminals share the same

directory number, the subaddress identifies which terminal will

answer a particular incoming call.

/SType subtype

The types of subaddress used, NSAP (default) or User. If you

include this option in the command, you must also use the /SAddr

option.

/BCtype bearer

Defines the Bearer Capability (i.e., the information-transfer rate

and mode). Possible values are 56K, 64K (default), or Packet.

56K and 64K are for circuit-switched services, while Packet is

the equivalent of 64K for packet-switched services.

/Port p | portname

The Eiconcard port number or port name through which you want

to dial. Port 1 is the default. With ISDN connections, this refers

to the Eiconcard channel you are using.

ECDIALER STORE [/Main n] [/ALternate n] [/NType t] [/NPlan p]

[/SAddr a] [/SType t] [/Tns t] [/BCtype b]

[/Port n|portname] [/Outfile f]

1 2 ... 77 78 79 80 81 82 83 84 85 86 87 ... 214 215

Žádné komentáře

Eicon Networks C21 Instalační příručka Strana 82